1973-1982 Corvette Cowl Cover

• Provides a clean look over the stock cowl area
• Reduces the collection of leaves and debris
• Will not interfere with your Corvette’s wipers
• Can be painted to match your Corvette’s paint

Installation of the 1973-1982 Corvette Wiper Compartment Cover requires very little modifications. If you are going to paint the cover do so before installing. Once you are ready to install the compartment cover you will need to trim the trailing edge of the firewall, this is best done with a file. After trimming, install the cover to check for proper fit. You should turn your Corvette’s Windshield Wipers on and then stop them half way up by shutting off the ignition. Each wiper arm should then be run through the corresponding hole in the wiper compartment cover. The cover is then slid down onto the firewall. If the cover sits flush with the top of the firewall and the trailing edge rests tightly against the windshield, proper fit has been achieved.

Corvette Wiper Compartment Cover

If you would like to strongly mount the Corvette Wiper Compartment Cover, though it is not required, simply use four strips of adhesive backed velcro. Each strip should be approximately 4″ long and should be 3″ and 10″ from the side of the cover. If placed correctly the two front strips should fall directly on top of the firewall with the rear strips attaching to the windshield glass. If minor interferences are noticed you may have to file away the necessary amount of material.